Crary CWS CASE IH 2162, Руководство пользователя и каталог запчастей, Страница: 38 / 92

PN 50887-00 Case IH 2162/MacDon FD1, FD70, FD75 Crary Wind System Owner’s/Parts 30
ASSEMBLY
4.7 DROP TUBE ASSEMBLY
MANIFOLD
LENGTH
# OF SHORT
DROP TUBES
# OF LONG
DROP TUBES
30 FT (12” SPACING) 2 27
35 FT (12” SPACING) 2 33
40 FT (12” SPACING) 2 37
45 FT (12” SPACING) 2 43
When installing the drop tubes, start working from the LH
side (as looking from the combine cab) of the manifold and
work to the right.
1. Apply the self adhesive foam seals, if not already in-
stalled.
A. Remove and discard the slot and two hole
cutouts from the self adhesive foam seal.
B. Remove the self adhesive foam seal from the
backing and apply foam seal to drop tube.
2. To connect an air tube, place it on one of the holes in
the manifold and point the end towards the direction of
the cutterbar.
3. Place a U-bolt around the manifold and through the
holes on the drop tube weldment.
4. Secure the drop tube with two 5/16” flange nuts
(Figure 38). Torque to 11 ft-lbs.
5. Repeat procedure for all drop tubes.
6. Installation of short drop tubes will require drilling one
1-9/16” hole on each end of head. Short drop tubes
should be evenly spaced between last two tines on
the reel. Before drilling, ensure hole aligns with other
holes on manifold.
Figure 38: Drop tube assembly
U-BOLT
FOAM SEAL
U-BOLT
5/16” SERRATED
FLANGE NUT
AIR TUBE
WELDMENT
NOTE
Over torquing can damage casting and manifold.
3.25”
Figure 39: Bending End Fingers
7. If the optional End Finger Kit is installed, use an ap-
propriate tool to bend the end fingers on the RH side of
the header so that there is 3.25” between them and the
end reel tines to allow clearance for the end drop tubes.