Crary CWS CASE IH 2162, Руководство пользователя и каталог запчастей, Страница: 34 / 92

PN 50887-00 Case IH 2162/MacDon FD1, FD70, FD75 Crary Wind System Owner’s/Parts 26
CAUTION
Be sure the reel is secure and will not move before be-
ginning installation.
ASSEMBLY
4.5.3 RIGHT HAND MOUNT
1. Assemble the bearings using the spacer, adaptor,
bearing and washer. Use a 3/8 x 5” bolt and nylock nut
to secure the bearings to the CWS mount weldment.
(Figure 33)
2. Remove the OEM cylinder mount from the reel arm and
save the hardware for later use (Figure 30).
3. Set a CWS tube mount weldment on the OEM RH reel
arm. Slide it back against the OEM bracket shown in
Figure 33.
4. Attach the CWS tube mount weldment to the OEM
bracket. To do so, replace two existing bolts with 3/8”
x 1-3/4” bolts and washers (Figure 33). Install a .63”
spacer on each bolt between the CWS tube mount
weldment and OEM bracket. Use one 1/2” x 1-1/2”
carriage bolt, washer and nut to bolt the bottom hole
of the CWS tube mount weldment to the OEM bracket.
5. Using a 1/2” x 3 1/2” carriage bolt and locknut, attach
an end hole of the arm mount tube to the clevis of the
CWS tube mount weldment (Figure 31).
6. Insert a reel mount assembly into the arm mount tube.
7. Attach the adjustment strap to the arm mount tube and
reel mount assembly with a 1/2” x 3-1/2” bolt, nut and
spacer (Figure 33).
8. Attach the bottom end of the adjustment strap to the
front hole of the CWS tube mount weldment with a 1/2”
x 1-1/2” carriage bolt and nut.
9. Position the side tube mount as shown in Figure 31 &
Figure 33 onto the OEM reel mount. Install a 5/16 x
1-1/4” bolt in the upper left corner. Using the bracket
as a template to mark and drill the other hole using a
11/32” drill.
10. Bolt the side tube mount to the OEM reel mount using a
.50” spacer between the bracket and the OEM mount.
Use a 5/16 x 1-1/4” bolt, nut and washer to secure in
place (Figure 33).
11. Install a new cylinder mount weldment to end of OEM
real arm using the OEM hardware removed in step 2
as shown (Figure 32).
12. Reconnect cylinder reusing the OEM hardware (Figure
32).
4.5 REEL ARM MOUNT (FD70 & CIH 2162 HEADERS)
Figure 30: Right hand reel arm (FD70 & CIH 2162 headers)
Figure 31: Tube Mount (FD70 & CIH 2162 headers)
Figure 32: Cylinder Mount (FD70 & CIH 2162 headers)