Crane Merchandising Systems Genesis, Техническое руководство

Страница: 92 / 128

closes correctly and does not leak.
N.B. In most cases this procedure is enough to stop the leaking. Should the
brewer still leak, repeat the above procedure, adding one more shim. If the
problem still persists, remove all of the shims and turn the T-bar one complete
revolution clockwise. Re-insert the T-bar into the H frame and test vend as above.
4. If the tension is adjusted correctly but the brewer is still leaking, do not increase
the brew chamber tension further. Check the brewer to ensure there is no loss
of vacuum, usually caused by a cracked, worn or scored cylinder, or a worn teflon
piston seal.
11.4 Adjusting The Cup Drop Mechanism
When changing the type or size of cup vended from the machine, it may also be
necessary to adjust the cup drop mechanism to accommodate the new cups.
Proceed as follows:
1. Open the front door and swing the cup turret assembly out of the machine.
Carefully lift and remove the four transparent cup sleeves from the cup drop unit.
Discard any cups that may be left over.
2. Place a minimum of 4 new cups into the cup splitter. Observe the clearance as
shown in the illustration below.
N.B. Clearance indicated in Correct Adjustment diagram should be no more than
half the diameter of the cup lip (maximum) but just enough to allow for smooth
cup ejection.
3. If necessary adjust the cup ring to obtain the
clearance as shown. Loosen the adjustment arm
screw (a) and move the adjustment arm (b) until
the correct clearance is achieved. Hold adjustment
arm in place and retighten the adjustment screw.
N.B. Move the arm clockwise if adjusting for larger
diameter cups and anti-clockwise for smaller cups.
90
Technical Manual