Crane Merchandising Systems Genesis, Техническое руководство

Страница: 11 / 128

Section 2 - Installation Procedure
Important! It is essential that personnel responsible for installing,
commissioning and servicing the machine understand the following:
1. The installation and commissioning of the machine should only be carried out by
trained and authorised service engineers.
2. All water and electrical services must be correctly and safely connected.
3. All covers should be replaced correctly and securely and the machine left in a safe
condition.
2.1 Locating the Machine
1. The machine is suitable for indoor use only, sited in an area with a recommended
ambient temperature not below 10º C and not exceeding 30º C. The machine
should be located near the appropriate water and electrical services as detailed
in the specification table.
2. Prior to moving the machine to its location, ensure that there is sufficient access
space available via passageways, stairs, lifts, etc and that the table/counter where
the machine is to be located is strong enough to safely support its weight. (Refer
to Specifications Table).
3. To ensure adequate ventilation, 100 - 150 mm (4 - 6 inches) clearance must be
allowed between the back of the cabinet and the wall.
4. Open the cabinet door using the key provided. Remove all transit packing and the
installation kit from the machine. Check for visual signs of damage which may have
occurred during transit. If the machine is damaged or any parts are missing, you
must contact the supplier immediately.
5. Referring to the diagram opposite, fit the four feet (1) to
the machine. Ensure that the spacer (2) is fitted between
the washers (3) as shown. Using a 12 mm spanner, adjust
the feet until the machine is levelled in both front to back
and side to side planes.
6. Fit the door switch bracket to the door using the two
screws provided. Ensure that the bracket operates the
door switch when the door is closed.
9
Technical Manual