Crane Merchandising Systems Genesis, Техническое руководство

Страница: 91 / 128

4. Re-assembling The Brewer To The Machine
1. Carefully slide the brewer chamber/wipe arms
assembly into the brewer unit.
Important: The wiper arm lug (a) must be located
between the stainless steel arms (b) as shown.
2. Line up the brewer unit with its mounting bracket
ensuring that the drive shaft correctly engages with
the brewer motor drive dog. Push the brewer unit
into place and secure with the sprung pin.
3. Refit the coffee dispense pipe/outlet adaptor to the coffee brewer outlet and the
tea dispense pipe to the tea brewer outlet. Re-assemble the coffee and tea water
inlet pipes to their locating brackets.
4. Refit the brewer guard and close the front door of the machine.The machine will
power up and the brewer will index to its home position.
5. Brew Chamber Tension Adjustment
If a leak develops between the brew chamber and the filter screen assembly during a
brew cycle, it may be necessary to adjust the brew chamber tension arm. The leaking
is an indication that the brew chamber is not closing correctly. Proceed as follows:
1. Open the door and insert the door switch safety key. The machine is now on.
Press the Brewer Open switch (2) located in the service keypad on the rear of
the door. The brewer will index to its fully open position and stop. Remove the
safety key.
2. Lift the latch bar and remove the brewer
chambers/wipe arms assembly. Push down on
the ‘H’ frame (1) and remove the T-bar (2)
from the recess. Add one full shim or half
shim (3) into the recess and replace the T-bar.
Important: Do not add several shims at
once as assembly may become over
tensioned, causing damage to the brewer bearings and vertical rod housings.
3. Re-install the brew chambers/wipe arms assembly into the brewer unit. Insert the
door switch safety key and allow the machine to power up. Test vend several
freshbrew drinks through the brewer to ensure that the brew chambers assembly
89
Technical Manual
a
b
b