- 13 -
FLEX 200
3.5 Requirements of the installation site
Environment requirements for the site where the machine is to be used:
•
Clean and dust-free.
•
With level and stable floor.
•
Fitted with a grounded power supply socket.
•
Equipped with sufficient lighting to ensure good visibility from every point of the machine (light value not lower than 500
Lux).
•
Ventilated to prevent the concentration of harmful fumes: for example,for a 3 m high, 4x4 m room (total volume of 48 m
3
)
an air change rate (ac/h) of 3 required.
•
Temperature between 10 °C (50 °F) and 40 °C (104 °F) and relative humidity between 5% and 85%, without condensation.
WARNING
The environment working conditions are strictly related to the type of colorants used (ask for information from the paint
manufacturer). The requirements indicated above are valid for the machine only.
Do not place the machine near heat sources or in direct sunlight. Also humidity sources should be avoided. The machine
must be used indoors only.
Environment conditions outside the values indicated (chapter 8.1) may cause serious damage to the machine, especially
the electronic equipment.
DANGER
When using
colorants containing volatile solvents
, the room in which the machine is installed must be spacious and with
good ventilation: for example, for a 3 m high, 4x4 m room (total volume of 48 m
3
) an air change rate (ac/h) of 3 required.
No type of parts must be leant against or stocked close to the machine.
Avoid naked flames or materials that may create spark and cause a fire
It is forbidden to smoke in the machine nearby area.
3.6 Safety devices
When top cover is lifted, the safety switches are activated. The machine commands are interrupted. The ON lamp blinks fast
to indicate the machine is switched ON (Refer to the table).
DANGER
In the event of breakdown of the safety device, it is forbidden to use the component not provided by manufacturer. In case
of need, contact only service organization authorized by manufacturer.
Top cover
Status of
the ON
lamp
Machine
condition Meaning
Placed
ON
On-line
The machine is ON and ready to receive commands coming from the computer.
Removed
Blinking
fast
Off-line
The machine operates in a restricted mode. Certain functions like dispensing,
timed processes etc. are disabled for safety reasons. However, service functions
are enabled for a service engineer to diagnose the machine.
