Cooper Surgical F9 Express, Руководство пользователя

Страница: 43 / 91

F9 Fetal & Maternal Monitor • User Manual
- 37 -
6.4 Setting Date and Time
1) Select the Setup key on the main interface.
2) Select
Date and Time
.
3) Set the year, month, date, hour, minute and second. The first three numbers are used to set the
year, month and date. Their orders vary with the preset Date Format below.
4) Select
Date Format
for the format of the date;
yyyy-mm-dd,
mm/dd/yyyy (default), or
dd/mm/yyyy.
5) Select
OK
.
NOTE: The date and time remain in the F9 Monitor after it is switched off for at least two
months. You do not have to reset the date and time before each usage.
6.5 Connecting the Transducers
Check for visible damage to the transducers each time before connecting them to the monitor. Pay
special attention to the seams on the transducers and cables before immersing them into conductive
fluid. If damage is found, replace them.
When plugging transducers into the Monitor, make sure the arrow symbol of the connector is facing
up. Refer to Figure 6-2.
When disconnecting a transducer, hold the body of the transducer collar (the shaded part shown in
Figure 6-3) with fingers, push it in slightly, then pull it out.