CONVEY-ALL CST-1550, Руководство оператора

Страница: 28 / 62

3-6 Revised 05.2021
Operator’s Manual: CST-1550
Fig 20 - Limit switches controlling rear conveyor movements
Fig 21 - Hopper access panel
Fig 22 - Rotation centre limit switch
Rear (Incline) Conveyor:
The rear conveyor uses a rubber, paddle belt. It is
26 feet long, and is stored along the passenger-
side of the tender. It needs a 26 feet radius to
swing around, and be positioned below the
slave conveyor discharge to move product.
There is an access panel below the hopper
which can be opened to clean the belt.
When the conveyor frame is centred below
the slave conveyor’s discharge, the conveyor
can swing in a 114° arc. At a 40° angle, its
discharge height is 17’ 4”.
CONVEYOR MOVEMENT HAZARD
Clear area before moving the conveyor.
Movements may be sudden causing injury.
CONVEYOR DAMAGE HAZARD
Periodical adjustment of the limit switches may
be necessary after long travel/rough roads.
There are five limit switches to control the
conveyor’s movements. Each switch is labeled
(L#) for wiring on the circuit board. They are
listed below in order of operation:
Rotation Centre Limit Switch (L3):
This switch will activate when it contacts the
plate as the conveyor swings 180º from stow
position to point directly back from the tender.
The Green LED (on the light box at top, rear of
tender) will illuminate when the rear conveyor
has triggered the switch.
• The conveyor must be at rotation centre for all
other movements to happen.
Once the rear conveyor is below the slave
discharge, and the shuttle centre switch is
activated, the conveyor can swing, lift and
lower into working position.
L1
L5
L3
L2
L4