CONVEY-ALL CST-1550, Руководство оператора

Страница: 45 / 62

Operator’s Manual: CST-1550
01.2019 4-3
Fig 59 - Slave conveyor drive
Fig 60 - Rear conveyor drive
4.2 SERVICING INTERVALS
Use the Service Record provided on page 4-11,
to keep a record of all scheduled maintenance.
The conveyor belt alignment is preset to run
true under a condition of no load. It is important
to check alignment and make adjustments, if
required, during the initial few minutes of loaded
operation.
Check bearings for wear daily.
The following recommended periods are based
on normal operating conditions. Severe or
unusual conditions may require more frequent
lubrication and servicing.
IMPORTANT:
For engine servicing and maintenance,
refer to it’s manual for complete details.
4.2.1 Every 10 Hours or Daily:
1. Check fuel level.
- Add as required.
2. Check oil level in hydraulic reservoir.
- Add as required.
3. Inspect conveyor belt lacing for wear.
4. Check the conveyor belts’ tension daily
while breaking-in the tender.
- Refer to Section 4.3.1
5. Check the conveyor belts’ alignment
frequently during the first 10 hours of
operation until it seats itself.
- Refer to Section 4.3.2
6. Inspect all rollers and bearings for play and
wear.
- Replace if necessary.