CONVEY-ALL CST-1550, Руководство оператора

Страница: 26 / 62

3-4 Revised 05.2021
Operator’s Manual: CST-1550
Note:
The Floater Valve must be activated
to manually operate the belt valves.
g. Conveyor belt motors valve
h. Slave conveyor belt valves
i. Slave belt speed adjustment dials
Note:
Belt valve heads may be a
push/pull or threaded stem type.
- Pull up and rotate a half-turn to lock.
- or -
- Rotate the head fully open (up) or
fully closed (down).
One of these actions will run the belts.
g. Conveyor belt valve operation:
Pull up (or rotate) to run both belts.
h. Slave conveyor belt speed adjustment:
- Pull up (or rotate), one of three valves, to
run belt at that speed.
- Left valve is speed 1, middle valve is speed 2,
Right valve is speed 3.
i. Adjust the slave conveyor belt speed:
- Rotate to loosen the lower dial.
- Rotate the top dial; up to increase speed,
down to decrease speed.
- Tighten the lower dial when done.
Hydraulic Valve Bank:
The wireless handset will operate functions.
All tender functions can also be manually
controlled at the bank of hydraulic valves
mounted on the rear, left frame. Each valve is
designed with a flow control as part of the base.
a. The Floater Valve is behind the pressure
gauge on the left-hand block.
- Note: This overrides the remote control.
- Rotate the floater valve stem fully open
(up) to activate the manual valve functions.
- Close the valve stem to deactivate.
b. Gate Valves:
Six gate valves are in a row.
- Pull up the valve head to open the gate.
- Push down, to close the gate.
c. Swing Rear (Incline) Conveyor:
- Pull up the valve head to swing conveyor
around to the left.
- Push down, to swing it right.
d. Rear (Incline) Conveyor Angle
(Raise/lower rear conveyor discharge):
- Pull up the valve head to raise the discharge.
- Push down, to lower it.
e. Shuttle Rear (Incline) Conveyor:
- Pull up the valve head to slide conveyor left,
horizontally along the rear frame.
- Push down, to slide the conveyor right.
f. Transport Rear (Incline) Conveyor
(Drop/lift rear conveyor):
- Pull up the valve head to drop conveyor,
lower than the slave conveyor.
Note: Once below, it can be shuttled into
working position.
- Push down, to lift the conveyor.
Note: When lifted fully, it can be swung
around into transport position.
Note:
Slave and rear (incline) conveyor motors
are connected and run by the same valve.
Fig 14 - Valve blocks
b
Pressure
Relief
Valve
Pressure
Relief
Valve
a
h
g
c d e
f i