Ref.no.: 003274/Revision 2.4 @2019 Control Data Systems Page 25
|
201
5.2.1
Provisioning
1.
If the device that is being provisioned is already joined to a running network
, it must be reset
to its factory default settings, by pressing the
Reset To Default
button for 10 seconds (see
Figure
5.2.5
). After the LEDs have stopped blinking, continue to step 2.
2.
If data about the device already exists, go to step 3
. Under
Device Provisioning
,
Manage
Provisioning Data
tab, add data about the device by clicking on the
Add
button. In the window
provide the following:
a.
EUI-64 Address (found on a label on the device or on a tag attached to the device, e.g.
0022:FF00:0002:BA84)
b.
Device Tag (a representative name for the device, e.g. VS210_BA84)
c.
Network ID (can be found in the VR950’s MCS website, under
Gateway
,
Subnet ID
)
d.
Join Key (can be found in the VR950’s MCS website, under
Gateway
,
App Join Key
)
e.
Check
Enable Simple APISupport:
•
Data Publication Period (interval between 2 publishes)
•
Attribute ID:
-
UAP_DATA_ANALOG_2 (provides
temperature
readings)
-
UAP_DATA_ANALOG_3 (provides
humidity
readings)
f.
Press
Save.
g.
Move to step 3.
