Consilium Salwico CS4000, Руководство по установке

Страница: 97 / 277

Service & Maintenance manual Chapter 4: Replacing/Adding/Deleting fire detectors
Salwico CS4000
8
Chapter 4: Replacing/Adding/Deleting fire detectors
Replacing fire detectors
Instruction
1. Disconnect the faulty detector and remove it from the
base plate.
Note : Some bases have a lock mechanism on the side.
This lock shall either be pulled or pressed (depends on
base model).
2. Check the ID settings on the address switch for the faulty
detector. See section “ID address on DIP switches” for
explanation of the ID address.
3. Set the corresponding ID on the address switch for the
new detector.
4. Seal the address switch on the detectors with the attached
label after the address has been set.
5. Connect and mount the new detector.
6. Check and reset any fault codes generated by the
replaced faulty detector.
7. Perform a function test of the detector according to the
chapter
Testing .
ID address on DIP switches
All addressable loop units must be given an address between
1-254 to be operational. The loop units located on the same
physical loop must all have unique addresses. The address is
set either by a 8 pole DIP switch located on each addressable
unit, or (for units without physical address switch) with the
address programming tool EV-AD. (See separate instruction)
The DIP switch values follow the binary system.
1 2 3 4 5 6 7 8
O
N
1 2 4 8 16 32 64 1 28
The value of the address is set according to the switches set
to ON position. For example:
1 2 3 4 5 6 7 8
O
N
=47
The switches numbered 1,2,3,4 and 6 are set to ON position.
The values for these switches are 1+2+4+8+32=47.
Important:
Seal the address switch on the detectors with the
attached label after the address has been set.