Consilium Salwico CS4000, Руководство по установке

Страница: 181 / 277

Intrinsically safe isolator
Salwico ISOLATOR-A
Part no. N1790
System: Salwico CS3000*, CS4000 and NSAC-1 Fire Alarm
Specifications may be subject to change for improvement without prior notice Data sheet no: N1790.10.2.E
Page 1 of 2
Consilium Marine AB
P.O. Box 8763, SE-402 76 Göteborg
Phone +46 31 7107700 Fax +46 31 7107800
www.consilium.se
Description
ISOLATOR-A is an IS isolator intended for use together
with Salwico intrinsically safe addressable detectors and
manual call points. It contains an IS-isolator and a LISA-2
connection board.
ISOLATOR-A is located in a non-hazardous area (safe
area) and forming the interface to IS detectors and other
IS line units.
To each addressable detector loop a maximum of five
ISOLATOR-A units can be connected, each of them
accommodating up to 20 IS line units.
ISOLATOR-A does not need a separate power supply or
earth connection. It is powered directly from the fire
alarm panel via the loop cable, which means that no extra
cables are needed.
The cable glands shall be mounted acc. to the dimension
drawing on page two. This will guarantee the minimum
required distance (50mm) between the intrinsic safe and
the non intrinsic safe conductors. The conductors shall be
as short as possible between the entrance and the
terminals and shall not cross from one side to another.
The connection board LISA-2 simplifies installation and
replacement by offering a connection solution without
breaking the fire alarm loop.
The resistor mounted on the ISOLATOR output should
not be removed.
Data, Isolator A
Operating voltage 19-38VDC
Working voltage 35VDC
Approval EEx ia
Cable terminals 2.5 mm
2
Ambient temperature -20ºC to +60ºC
Ambient humidity 0-100% RH (when mounted in
box)
Weight ~100 g (isolator)
ELR 10k Ω (for load only)
Data, enclosure
Ingress protection IP55
Cable glands Ø8-14 mm
Material Polystyrol
Colour Grey,
Blue
Weight ~700 g (incl. internal
components)
Spares
Part. No. Type
46492 Fuchs KFD0-CS-Ex1.54
5200094-00A LISA-2 connection board
*SPK-2 for NOSE based detectors
Connection
+
-
10k
Ω
-
+
ISOLATOR
2(-)
1(+) 11(+)
12(-)
LISA
Last IS unit
(max 20)
ISOLATOR-A
Loop out
Loop in
23(+)
24(-)
22(-)
21(+)
32(-)
31(+)
IS-LINE UNIT
Safe area Hazardous area