Consilium Salwico CS4000, Руководство по установке

Страница: 65 / 277

User Guide Chapter 1: General description
13
Salwico CS4000
3.1.2 Detectors & Manual Call Points
Possibility to disconnect individual detectors or manual call points for a
specified time period or permanent.
3.1.3 External Controls
Possibility to de-activate all External Controls or Alarm Transfer.
3.1.3.1 All External Controls
Disconnects all outputs to external controls. This means that an alarm
condition will not cause any doors to close, fans to stop etc.
3.1.3.2 Alarm Transfer
Disconnects the supervised output for alarm transfer, normally used in
on-shore installations to alert the fire brigade in case of a fire alarm.
3.1.4 External Alarms
Disconnects outputs to external alarm or activates alarm delay.
3.1.4.1 Alarm Device (Bells etc.)
Disconnects outputs for alarm devices, such as audible- (bells etc) and
optical alarm devices.
3.1.4.2 Alarm Delay
Activates the programmable alarm delay time. When alarm delay is
activated there is a delay time between when a fire is detected until the
alarm device outputs are activated.
3.1.5 Test Mode
Possibility to set a zone into test mode. See chapter 3 Installation under
“testing” for more details.
3.2 Disconnection list
Shows all active disconnections in the system. A periodic disconnection
(3.3) that is not active will not be shown in this list. Reconnection of a
disconnected unit is made from this list. See chapter 2 Operations under
“reconnection of disconnected items” for more details.
3.3 Periodic Disconnection list
Shows all periodic disconnections in the system. Removal of periodic
disconnections is made from this list.
3.4 Old Disconnections
A list showing the 150 latest, previously removed, disconnections. This
list also gives the possibility to re-activate an old disconnection again.
This function is very useful if the same disconnection is frequently
needed during irregular time periods. Just mark the appropriate old
disconnection in the list and press 0 to re-activate it.