Conrad 1484607, Руководство по эксплуатации, Страница: 25 / 40

25
Roll trimming:
If the helicopter tries to drift or top to the right, reduce the speed until the helicopter is safely on its skids again. Now
push the trim button for the rolling function (also see figure 1, item 5) to the left several times.
Push the pitch stick carefully forward and check if the adjustment was sufficient. Repeat the procedure until the model
does not show any tendency to drift to the right.
If the helicopter tries to drift to the left, push the trim button for the rolling function to the right.
The display shows the change of the rolling trimming at the trimming display (see figure 5, item 7). The set
value is stored automatically.
Figure 18
Nod trimming:
If the helicopter tries to drift forward, reduce the speed until the helicopter is safely on its skids again. Now push the
trim button for the nodding function (also see figure 1, item 4) down or towards your body several times.
Push the pitch stick carefully forward and check if the adjustment was sufficient. Repeat the procedure until the model
does not show any tendency to drift to the front.
If the helicopter tries to drift backwards, push the trim button for the nodding function up or away from your body.
The display shows the change of the rolling trimming at the trimming display (see figure 5, item 6). The set
value is stored automatically.
Figure 19
If the adjustment areas of the nod and roll trimming are not quite adequate for an optimum correction, you
adjust control of the main rotor blades mechanically. Further information on this can be taken from the fol-
lowing chapter: Fine Tuning of the Model Helicopter.