Conrad 1484607, Руководство по эксплуатации, Страница: 15 / 40

15
10. Operation of the Model Helicopter
a) Charging the Flight Battery
The flight battery is charged with the enclosed USB charging adapter. For this, the adapter is connected to a USB
socket of a computer/notebook or a commercial USB plug-in mains adapter with the also-enclosed USB plug-in
charger.
Attention!
Do not connect the USB cable to a USB hub without a separate mains adapter (e.g. a keyboard USB port,
etc.), because these will not provide sufficient current for charging.
Connect the flight battery (1) to one of the connection sockets
protected against polarity reversal (2) of the charging adapter.
Work with the required care and do not apply any unnecessary
force.
An optionally available spare flight battery can be connected to
the second charging output (2). It is then charged at the same
time.
Then connect the miniature USB plug (small plug) of the USB
cable (3) to the charging adapter according to the figure.
Once you connect the USB plug (large plug) of the USB ca-
ble to a USB socket of a computer/notebook or a USB plug-in
charger, charging commences.
Each charging output has its own LED display (4), which lights up red while charging. When charging is completed,
the display of the charge indicator LED switches from red to green.
Disconnect the rechargeable battery from the charging adapter right after charging and pull the USB plug
from the computer/notebook or plug-in charger. The two charging chutes above the LED displays (see
fig. 7, item 5) may be used if needed to charge rechargeable batteries of other small models with the cor-
responding plug-in socket. In connection with the model helicopter "HFP80", however, the charging chutes
are not needed.
Important!
Only charge one rechargeable battery per side (shaft or cable connection). Never try charging two re-
chargeable batteries (shaft and cable connection) on one side of the charging adapter at once!
Remove the flight battery from the model for recharging!
Place the flight battery and the charging adapters on a fire-proof underground when charging and do not
charge the battery unsupervised.
The operating system does not recognize any new hardware after connection of the charging cable, be-
cause the USB port is only used for power supply. Please observe that the USB ports of your computer/
notebook are usually only active when the computer/notebook is switched on.
Therefore, we recommend to only connect the charging cable to a computer/notebook that is switched on.
Figure 7