Mounting Instructions
ProfiDAT
®
Data Transmission System
Programm 0514
MAL0514-0005b-EN
www.conductix.com
translated document
page 48 of 82
Fig. 36: Insulation profile (1) aluminum rail (2) clamping surface (A)
The cutting direction (1) must be from the open profile side, so from top to bottom (see Fig. 35).
Saw insulation profile and aluminum rail separately and at right angles with a chop saw. Use the clamping surface A (see
) so that the inside of the aluminum rail is not deformed.
After cutting the aluminum rail, make a chamfer of max. 0.3 mm x 45° on the aluminum rail with a key file (see Fig. 37). This is
important to prevent wear of the sliding contact! Remove burrs from all other sharp edges with a key file!
Fig. 37: ProfiDAT
®
profile burr-free
1
A
2
0.3 mm x 45°
External edges
burr-free
Internal edges
burr-free
