Mounting Instructions
ProfiDAT
®
Data Transmission System
Programm 0514
MAL0514-0005b-EN
www.conductix.com
translated document
page 11 of 82
2.4
Intended Use
The data-transmission system is designed and built exclusively for the usage described here (intended use).
WARNING!
Hazard due to improper use!
Any application that deviates from or goes beyond the intended use of the devices can result
in hazardous situations.
Strict compliance with the specifications of this installation manual is required.
Refrain from improper use of the system.
Respect the instructions on improper use in chapter
Intended use
The ProfiDAT
®
data-transmission system is used for data communication between a base unit and a mobile system component.
In addition to the capacity to transmit data, the ProfiDAT
®
profile can also be used as a ground conductor rail together with conductor
rails in product ranges 0813/0812 (max. 1000 V/max. 1000 A).
Transmission of electrical power is not permitted.
The system comprises at least one access point and one client transceiver, together with the corresponding infeed and consumer
antennas.
Compliance with these technical conditions is mandatory for the installation:
The maximum permitted traversing speed of the mobile transceiver is 5 m/s.
The profile may only be installed horizontally with the access aperture facing down.
Side access is also feasible after prior technical testing and approval by the manufacturer.
Electrical-engineering operating conditions:
The electrical system must be protected in accordance with local regulations and guidelines.
The system may only be installed on the PE profile (protective conductor, green/yellow).
2.4.1
Improper use
Claims of any kind due to damage incurred during use that deviates from the intended use described above ("use other than the
intended use") are excluded.
The owner bears sole liability for any damage resulting from improper use.
Improper use in particular includes the following forms of use:
Operation that does not comply with the specified operating conditions (see chapter 3.5)
Use of the ProfiDAT
®
profile for the transmission of power
Use where there is a risk of explosion (“Ex”-classified zones)
Use of the transceiver without the profile
Use of transceivers not supplied by Conductix-Wampfler
Use of the system parallel to a conductor rail system of a brand/type not approved by Conductix-Wampfler
Use of the system with accessories that are not approved and not authorized by the manufacturer
Use of the system by untrained personnel
