Mounting Instructions
ProfiDAT
®
Data Transmission System
Programm 0514
MAL0514-0005b-EN
www.conductix.com
translated document
page 45 of 82
Fig. 28: Installed anchor point
Work steps:
Fig. 29: Marking the gap on the insulating profile
Mark the distance from the hanger clamp and interfaces on the insulating profile.
Mark the two sections A and B so that they are not confused during installation.
The gap must be at least 86 mm.
Remove the insulating profile from the aluminum profile.
Fig. 30: Trimming the insulating profile
Cut the marked gap out of the insulating profile. When doing this, insert a surplus piece of ProfiDAT
®
profile (an offcut, for ex-
ample) into the insulating profile so that it does not break during the cutting process. See also chapter 6.4.7.
A
B
A
B
