94 - VPN | OpenVPN Client Settings Page
RocketLinx WR7802-XT Series User Guide
: 2000638 Rev. A
Configuration Using the Web User Interface
Note:
You must
Save
) settings, if you want to maintain these settings if the WR7802-XT is rebooted.
Port
Enter the port number that your VPN service uses.
Note:
You may need check your VPN server to verify the port settings.
Tunnel Protocol
Select
TCP
or
UDP
to establish the VPN connection.
Encryption Cipher
Select the encryption cipher from
Blowfish
or
AES
.
Hash Algorithm
Select the hash algorithm from these selections:
SHA1
,
SHA256
,
SHA512
, and
MDS
.
Ping-timer-rem
Select enable or disable this function to prevent unnecessary restarts of the
server/client when the network fails. The default is
Enable
.
Persist-tun
Select enable or disable the persist-tun function that keeps tun(Layer 3)/
tap(Layer 2) device linked up after the
Keepalive
timeout occurs. The default
value is
Enable
.
Persist-key
Select enable or disable the persist-key function that keeps the first key to
use if the VPN restarts after the
Keepalive
timeout occurs. The default value
is
Enable
.
Use LZO
Compression
You can choose to select LZO Compression or not. This function compresses
data to decrease the traffic but it also needs more CPU. The default value is
Disable
.
Keepalive
Select enable or disable the
keepalive
function, which is used to detect the
status of connection. The default value is
Enable
.
Ping Interval
Enter the ping interval. The range is from 1~99999 seconds.
Retry Timeout
Enter the retry timeout. The range is from 1~99999 seconds.
nobind
If
nobind
is enabled, the VPN client does not need to bind to a specific local
port number.
ifconfig
Enter the tunnel IP address that VPN should use.
Route
Enter the route IP and MASK. This is the target IP domain you can access
through the VPN tunnel.
Enable NAT
Enable NAT (Network Address Translation).
Save Log File
Save an OpenVPN Client log file.
OpenVPN Client Settings (Continued)
Beta
Version
