60 - Power over Ethernet | PoE Control Page
RocketLinx WR7802-XT Series User Guide
: 2000638 Rev. A
Configuration Using the Web User Interface
You can use these steps to configure PoE settings. Refer to the
following table if you need more detailed information.
1.
Select
Enable
from the drop list.
2.
Enter an appropriate
Power Budget
, the maximum is 62W.
3.
Enter an appropriate
Power Budget Warning Level
.
4.
Click the
Apply
button.
5.
Select
Enable
for the port or ports that you want to use as PoE
ports..
6.
Select the
Powering Mode
for the attached device.
7.
Enter the power
Budget
for the port. The range is 1 to 31W.
8.
Set the port
Priority
.
9.
Click the
Apply
button.
10. If desired, configure
PD Status Detection
for the
attached PoE devices.
a.
Enter the
IP Address
of the device attached to the
port.
b.
Enter the
Cycle Time
, which is the time reserved
per duration of the PD reboot. The range is from
10~3600 seconds.
c.
Click the
Apply
button.
Note:
You must
Save
(
maintain these settings if the WR7802-XT is
rebooted.
PoE Control
System Configuration
PoE System
Enable or Disable the system’s PoE power output function. This budget must
less than the input power. You must first enable this option before you can
configure the PoE characteristics.
Power Budget (W)
This is the maximum output budget of the PoE function. The router supports
two IEEE 802.3at PoE ports with a maximum power budget of 62W.
Power Budget
Warning Level(%)
The warning level is for system warning to alert the user when the PoE
system is drawing power that meets the warning level.
Beta
Version
