Comtech EF Data LGAN, Инструкция по установке и эксплуатации

Страница: 59 / 118

LGaN
Revision 0
Ethernet Interface Operation 4–19 MN-LGAN
RF Power Threshold Settings
Name Description
Max Forward Power
Set the threshold value for the Max Forward Power (dBm). Value of 00.00 disables this
function.
Min Forward Power
Set the threshold value for the Min Forward Power (dBm). Value of 00.00 disables this
function.
Max Reverse Power
Set the threshold value for the Max Reverse Power (dBm). Value of 00.00 disables this
function. Not displayed if not equipped.
Min Input Power
Set the threshold value for the Min Input Power (dBm). Value of 00.00 disables this
function. Not displayed if not equipped.
When the forward/Reverse/Input power monitor is set to Alarm or Fault instead of the factory default of
Mask , and the forward power drops below the specified value, the alarm/fault occurs.
Click [Submit Thres] to save any changes.
Reference
Name Description
Ref Freq Adjust
Enter a valid reference oscillator tuning voltage value from 0 to 4095. The default value is
set to 640. Displayed only when Internal Reference is equipped.
Ext Ref Mute Use the drop-down list to select the External Reference Not Present Mute Mode as either
Enabled or Disabled. Displayed only when Internal Reference is equipped.
Click [Submit Ref] to save any changes.
Serial Communication Settings
Name Description
Remote Address Enter a valid physical remote address from 0001 to 9999.
Baud Rate Use the drop-down list to select the operating baud rate as 2400, 4800, 9600, 19200, or
38400 baud.
Click [Submit Serial] to save.
FSK Address
Set the FSK (Frequency Shift Keying) Address from 01 to 15 . Used to control the Amplifer with the
Comtech Modem’s front panel.
Click [Submit FSK] to save any changes.