Comtech EF Data LGAN, Инструкция по установке и эксплуатации

Страница: 58 / 118

LGaN
Revision 0
Ethernet Interface Operation 4–18 MN-LGAN
4.5.3 Config Pages
Use the Configuration pages to configure all operating parameters for the LGaN. Click Amplifier , LNB ,
Redundancy, Mask , or Utility to continue.
4.5.3.1 Config | Amplifier
Figure 4-14. ‘Config | Amplifier’ Page
RF Module
Name Description
Amplifier Use the drop-down list to select OFF or ON.
Attenuation (dB) Enter a valid attenuation level (00.00 to 20.00 dB) in 0.25 dB steps.
Attenuation Offset
Enter a valid offset value, in dB (00.00 to 20.00 dB) in 0.25 dB steps. Used for
Redundancy’s offline unit to match Tx Gain to the online unit.
Displayed only when Redundancy is turned on.
Fault Recovery Use the drop-down list to select Automatic or Manual.
Mute Use the drop-down list to select Enabled or Disabled.
Aux Mute Use the drop-down list to select Enabled or Disabled.
Offline Mute Use the drop-down list to select Enabled, Disabled, MuteRx, MuteTx, LNB,
LNB, Mute Tx+Amp, or Mute Tx+LNB+Amp.
Displayed only when Redundancy is turned on.
Click [Submit RF] to save any changes.