Comtech EF Data LGAN, Инструкция по установке и эксплуатации

Страница: 105 / 118

LGaN
Revision 0
Serial Interface Operation 5–31 MN-LGAN
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
(Note that all arguments are ASCII
numeric codes between 48 and 57)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code and
Qualifier)
Response to
Query
(Target to
Controller)
Switch Bias Tee SBT= 1 byte
numeric
Command or Query.
Switches the bias tee into the through state, or into the off state. The
bias tee provides a means of muting the LNB. The SBT state will be
controlled by the amplifier mute state while running in redundant
mode, but while the unit is not in redundant mode the bias tee may
be set independently of the amplifier mute state.
0 = Off State (mute LNB)
1 = Through State (unmute LNB)
Example: <1/SBT=1
Note: To send this command the unit must have the bias tee option
installed otherwise a mode error will result. A mode error will
also result if this command is sent while the unit is running in
redundant mode.
Default Value: 0
SBT=
SBT?
SBT*
SBT? SBT=x
(See
description for
details of
arguments)
Summary Fault
Status
N/A 1 byte Query only.
Indicates the condition of the summary fault relay.
Where:
0 = Not Faulted (SumFLT_COM J6 pin K is not connected to
SumFLT_NC J6 pin M)
1 = Faulted (SumFLT_COM J6 pin K is connected to SumFLT_NC
J6 pin M)
Example:
<1/SFS?
>0001/SFS=0’cr’’lf’
SFS= SFS? SFS=x
(See
description for
details of
arguments)
SNMP
Authentication
Trap
Enable
SNA= 1 byte Command or Query.
SNMP Authentication Trap Enable
0 = Disabled
1 = Enabled
Example:
<1/SNA=0
SNA=
SNA?
SNA? SNA=x
(See
description for
details of
arguments)
SNMP
Enable
SNM= 1 byte Command or Query.
SNMP Enable.
0 = Disabled
1 = Enabled
Example:
<1/SNM=0
SNM=
SNM?
SNM? SNM=x
(See
description for
details of
arguments)