Comtech EF Data / Stampede
FX Series Administration Guide - Version 6.2.2
119
Chapter: FX Series Status
Section: FX Series ADC Status
MN-FXSERIESADM6 Rev 6
Network Status:
Network Status by Interface
This page shows various counters and status indicators of all network interfaces, including
management, auxiliary, and all LAN and WAN interfaces. If tagged VLAN In-Path interfaces have been
defined then stats for these will be individually be broken out. For example if you defined an in-path
interface on for VLAN 100, you would see a section for “eth3.100”. If you are intercepting traffic in-
line you will see a section for “br0”. The “lo” interface section represents internal loopback traffic. If
you are interfacing to WCCP in ‘layer 3’ mode, you will see a section called “greX” which reflects the
traffic redirected to the FX over a GRE tunnel
This screen is critical for diagnosing common network connectivity problems, such as bad
cables, incompatible link speed and duplex negotiations and Ethernet frame errors.
Sample below: (Note: Some reports may have pull downs to view additional information)
FX-4010 Interface and ‘Autosense’
The FX-4010 does not autosense cable type. Therefore if you are interfacing directly to a
modem device, without going through an intermediate switch, it is necessary to use a cross-
over cable.
WAN Interface Status
This page shows various counters and status indicators of the WAN interface.
This page is critical for diagnosing common network connectivity problems, such as
bad cables, incompatible link speed and duplex negotiations and Ethernet frame
errors.
