Comtech EF Data DT-4500 Series, Инструкция по установке и эксплуатации

Страница: 102 / 206

DT-4500 Series C- and Ku-Band Down Converters MN/DT4500.IOM
Front Panel Operation Revision 2
6–10
6.2.3.2 (CONFIG:) REMOTE (Remote Control) Submenu
Remote Control: Local
SERIAL ETHERNET
Use the   keys to select Local , SERIAL , or ETHERNET . Press ENTER .
6.2.3.2.1 (REMOTE:) Local
1) When you select Local mode, remote monitoring is possible, but
remote control is disabled .
2) A number of operations are possible in Local mode only. If you are
in Serial or Ethernet mode during such tasks, the unit alerts you to
this remote state:
Remote Mode: press ENTER
for local mode
, or
CLEAR
Press
ENTER
to switch to Local Mode to continue with your task, or
press
CLEAR
to exit the task and remain in the active mode.
6.2.3.2.2 (REMOTE:) SERIAL
Serial Mode = RS-232
Addr=001 Baud=9600 8-N-1
On the top line, use the

keys to set the mode to RS-232 or RS-485. Press
ENTER . On the bottom line, set the Serial address ( Addr ). Use the
 
keys to
select a digit, and then use the

keys to change that digit. The valid range of
addresses is from 001 (default) to 255 .
Next, set the Baud rate. Use the
 
keys to select a parameter, and then use
the

keys to select your desired baud rate. Available choices are 1200 , 2400 ,
4800 , 9600 (default) , 19K2 , and 38K4 .