Comrex BRIC-Link II, Руководство по эксплуатации продукта

Страница: 49 / 104

To add a new remote unit to the list, click the Add a new remote connec on icon ( ) on the right side of the
screen. A dialogue box will appear and require the IP address of the remote unit to be input (as seen in Figure 35 ).
The “Use CrossLock” fi eld should be set to “Yes”, and the Switchboard ID/MAC address of the unit on the far
end should be entered in the next fi eld. Users may assign a Remote Name and either choose an audio Pro fi le or
proceed with the “Default Pro fi le”, which is automa cally selected.
Note: When adding a remote, the default network port will be UDP 9000 . If the “receiving” unit is set for a non-
standard network port, it must be entered in the “calling” unit’s remote connec on entry, a er the IP address (e.g.
192.168.7.23:9004).
Connec on Password - This func on can be enabled on any Comrex codec to fi lter incoming connec ons. When
enabled, a empted incoming connec ons will be rejected without the proper case-sensi ve password. See page
36 for details on se ng an Incoming Connec Ɵ on Password in the System Se ngs tab. For outgoing connec ons,
the password is entered in the “Connec on Password” fi eld of the Remote Se ngs page and must match the
password set on the receiving end.
Pro fi le - Remote entries require selec on of an audio Pro fi le to determine which encoding algorithms to use, but
will use the system’s “Default Pro fi le” if nothing else is chosen. BRIC-Link II includes several factory pro fi les to
choose from, each of which enables a full-duplex link. Factory-provided pro fi les o ff er commonly used encoders
and se ngs, but are locked for edi ng to avoid losing access to their basic func onality. Depending on use and
environment, custom pro
fi les can be made in the Pro fi le Manager tab (see page 31 for more on audio pro fi les).
Note: While CrossLock generally supports the encoding algorithms that operate on any 4.x-level fi rmware, the more
data-intensive algorithms (e.g. Linear PCM and FLAC) are only supported on units running fi rmware version 4.3-p4
or higher.
Backup Remote - BRIC-Link II features an ability to have an automa c backup to a designated remote connec on.
A speci fi c backup connec on (for when the primary fails) is designated when a new remote is created. As shown in
Figure 36 , selec ng the backup op on opens a menu allowing selec on of other outgoing remotes that have been
created. The Backup Remote feature works in conjunc on with a remote entry’s Local Timeout parameters, which
are de fi ned by the chosen audio Pro fi le . BRIC-Link II can sense an IP Connec on failure, and will wait for a me
designated by the Local Timeout parameter. If the connec on is restored during this me, no backup will occur.
If the meout lapses without re-connec on to the primary remote, BRIC-Link II will automa cally connect to the