Comrex BRIC-Link II, Руководство по эксплуатации продукта

Страница: 21 / 104

Generally, it is recommended to con fi gure the Ethernet port of BRIC-Link II for a sta c IP. This will facilitate access to
the Web-based Interface with a browser and allow for easier con fi gura on of routers or fi rewalls (if necessary). If
the BRIC-Link II is to be installed on a managed LAN, Comrex recommends consul ng with the IT services provider
about obtaining a sta c IP address.
As men oned in the previous sec on, BRIC-Link II is con fi gured for DHCP by default. This means that it tries to
extract an unused IP address from the network router upon boo ng. To change the Ethernet IP addressing to sta c ,
select the “ default ” loca on at the bo om of the list (as shown in Figure 8 ) and change the “ IP Type ” to sta c . The
system will prompt a list of sta c se ngs as shown in Figure 9 .
As can be seen in Figure 9, the sta Ɵ c IP address , the Netmask , the Gateway Address , and at least one DNS Server
Address must be con fi gured in the proper fi elds to set a sta c IP address. Once that informa on has been input,
click the “ back ” bu on and select Apply Changes to have BRIC-Link II accept and ac vate the new Ethernet se ngs.
Note that if the IP se ngs of the Ethernet port have been changed, the connec on to the Toolbox interface will no
longer work. Click the “ Scan for Devices ” bu on on Device Manager to re-sync with the new IP address.