3-41
Compaq Professional Workstation AP400 Maintenance and Service Guide
DIMMs
To remove a DIMM:
1.
Perform the service preparations described on page 3-2.
2.
Remove the following components:
❏
workstation cover
❏
I/O bracket assembly (expansion board bracket)
NOTE
: If an AGP graphics controller is installed, it must be removed.
3.
Press outward on both latches of the DIMM at the same time
➊
. This releases the module
and pushes it partially out of the socket.
4.
Lift the module from the socket
➋
.
IMPORTANT:
Before replacing the I/O bracket assembly, read “Important Guidelines for I/O
Bracket Assembly Replacement” earlier in this chapter.
NOTE
: The system recognizes memory upgrades and automatically reconfigures the
workstation.
2
1
1
Figure 3-41. Removing a DIMM
To replace a DIMM and reassemble the workstation, reverse the above steps.
