41CPE112 Addressable Fire Alarm Panel – Installation and Programming Manual
41
7.4.2 Change Address
In this submenu the installer can change the address number of a device. To change address of a device, enter in the
installer’s menu - 4. ADDRESSING - 4.2. CHANGE ADDRESS.
The system automatically shows the first address in the system. Use the up and down arrows to select the address of
the device you want to change.
Use the button ‘CHANGE’ to switch to loop 2 if present in the system.
Press the right arrow button to switch to ‘NEW ADDRESS’ field.
Press right arrow button to move to field ‘NEW ADDRESS.
Use again the up and down arrows to find a free address in the system configuration - the active ‘SAVE’ functional
button (2) in the last row of the screen will appear. Press the ‘SAVE’ button and wait for a couple of seconds. If the
address changing is successful the message ‘SUCCESSFUL’ starts blinking on the screen. You can proceed with
changing other address or escape with ‘CANCEL’ button.
7.4.3 Self-Addressing
In this submenu the installer can perform self addressing procedure of devices to the system configuration. The self
addressing procedure is suitable when there are great amount of devices to be connected to the panel.
The new devices are prepared for connection to the system configuration - the loop line is ready but the devices are
not installed (the detectors and sounders are not mounted to the bases; the call points and modules are not connected
to the loop).
To perform self addressing, enter in the installer’s menu - 4. ADDRESSING - 4.3. SELF ADDRESSING. The panel
shows the first free address for every of the loops. Now the installer can start mounting detectors and modules one by-
one. The panel will set the displayed address number to the mounted device and automatically proceeds with next free
address in the system.
The self-addressing menu shows information about the total number
of devices connected to every loop.
On the third row the panel shows the first free address for every of
the loops. The panel skips all already set address numbers and will
jump to the next free address number.
The installer also can set manually the next address using the
functional buttons from 1 to 4. The ‘-’ will decrease the address
number and the ‘+’ will increase it. If by mistake the set address is not free, during the self-addressing procedure the
panel will skip it and will jump to the next free address number.
In self-addressing mode the panel waits for connecting the device to the loop, automatically sets the current address to
the device and moves to the next free address number. With every one added device to the system configuration the
address count will increasing to show the total number of devices connected to the respective loop.
The exit of the menu is with pressing the ‘CANCEL’ button.
IMPORTANT NOTES!
1. During the self addressing procedure leave minimum 10 sec time interval between connecting
the next device to the loop.
2. NEVER connect devices to both loops at the same time. Connect all devices to loop 1 first and
after that proceed with loop 2.
3. After completing the self addressing procedure test the devices with LED indication on.
