Page | 59
VASTRAJET
8.
Default Jumpers are not placed in
Main Board
9.
LVDS is not connected properly
10.
Incorrect pulley is used
Case 8
: Place Jumpers on the Main
Board, if not available.
Case 9:
Connect LVDS properly.
Case 10:
Use compatible pulley by
contacting Head Office.
Printer
Manager Not
Showing
“Ready”
1.
USB Cable is Loosely Connected to
the Printer
2.
USB Cable is Faulty
3.
Printer not Initialized
4.
USB driver is not Installed
5.
Main Board and Head Connector
Board (HCB) is not compatible (an
error appears)
Case 1
: Tighten the USB cable.
Case 2
: Replace the USB cable, if faulty.
Case 3
: Please refer to the
“
PRINTER NOT
INITIAL
IZING”
section.
Case 4:
Please refer to the “
Installing the
Printer Manager
” section.
Case 5
: Kindly contact to the Head Office
or CES.
Carriage
Stops During
Printing
1.
USB cable is loose or faulty
2.
Open heavy file that can slow down
the data transfer
3.
Ground wire is disconnected
4.
Encoder Scale is having ink stains
5.
Pulley teeth wear out or belt is
slipping
6.
Ripped file is having error
7.
Check I/P and O/P voltage in 24V SMS
(16.5 A) on full load. Voltage drop, if
any.
Case 1
: Tighten the USB cable or replace
it, if required.
Case 2
: Use compatible and small size
images for printing.
Case 3
: Connect the ground wire to the
system.
Case 4:
Check and Replace Encoder Scale
Case 5
: Replace the Pulley or carriage
Belt
Case 6
: Correct the ripped file error, if
any.
Case 7:
Replace the power supply, if
voltage drop is found and also check the
power Inlet to the machine.
Print Is
Shifting WRT
Fabric Or
Junk Printing
1.
Encoder scale is having ink stains
(print shows vertical color bands)
2.
Encoder sensor is not clean
Case 1:
Clean the Encoder scale, if
stained, or replace it, if faulty.
Case 2:
Clean the Encoder Sensor or
replace it, if faulty.
Print Is Blur
(Not Sharp)
1.
Improper Head height
2.
Improper head alignment
3.
Recommended ink not used
4.
Ink
stored
at
unfavorable
environment
5.
Head voltage is not properly fed in
Printer Manager
6.
Improper step calibration
7.
Vibration in movement:-
o
LM block is wear out
o
Incorrect pulley alignment
Case 1
: Correct the head height by
following the steps given in the
Head
Height Adjustment
section.
Case 2
: Calibrate the printer again by
referring the “
Head Alignment”
section.
Case 3 & 4
: Use only the recommended
ink and stored it in favorable
environment conditions.
Case 5:
Feed the Head Voltage value as
mentioned in the Print Head.
Case 6:
Correct the step calibration using
the Step Calibration section.
Case 7:
Perform the following actions as
per the requirements:
a)
Replace the LM block
