Page | 17
VASTRAJET
Water Tank and Washing Tub
Precaution:
•
Water tank should be placed near the water supply to avoid the wastage of pipe.
•
Appropriate distance should be maintained from the machine and washing tub.
Follow these steps to place the water tank and water tub:
Step 1:
Place the Water Tank to the back side of the machine.
Step 2:
Connect the Water Inlet and Drain pipes to the Water Tank.
Note:
Water Inlet has to be connected to the upper socket and water drain to the lower socket using the
tightening clamp.
Step 3:
Place the Washing Tub into the guiding U bracket.
Note:
Remember the following points:
•
Please confirm that sponge must be wet or soft. In case, it is not soft, then gets it soak with the
running water.
•
Actuator block gets stuck, then adjust the trolley wheels.
•
Carefully insert the Washing Tub, taking care about the machine wheels and pipes.
Step 4:
Fix the drain pipe clamps to the pipes.
Step 5:
Mount the clamp brackets to the Water Tank.
Step 6:
Connect the Washing Tub Inlet pipe to the Jetting Pump using the Tightening Clamp.
Step 7:
Place the Jetting Pump in the Water Tank.
Step 8:
Fill the tank with 3/4
th
of water.
Step 9:
Move the tub UP to match the screw’s holes of actuator and tub engaging brackets.
Step 10:
Screw two fasteners (one on each side) from the actuator brackets.
Step 11:
Connect the brush motor cable.
Step 12:
Gently insert the tub, as shown below:
Fig 8: Inserting the Water Tub
