Page | 31
VASTRAJET
Step 6:
Wherever the glue under the press roller is diminishing, pour the remaining glue over such areas.
Step 7:
When glue below the Press Roller seems to be diminishing at some areas, and becoming of higher
viscosity and uneven, person standing in front, should start spraying the cleaner liquid continuously till the
end.
Fig 30: Spraying the Cleaner Liquid
Step 8:
Later the cleaner liquid spraying should be done throughout the belt, until the remaining glue
appears to be deactivated, due to mixing of cleaner liquid.
Step 9:
Once the glue seems to be deactivated, stop spraying liquid, and do simultaneously and quickly
below steps:-
•
Slightly rotate the Press Roller in opposite direction, to move the sticky portion upwards
away from the belt.
•
Lift the Press Roller from the both sides at a time and stop the glue cycle immediately from
the HMI screen.
Fig 31: Lifting Up the Press Roller
Step 10:
Remove the excess deactivated glue and throw in the waste bin. Wipe up only the area where
liquid is present, touching dry belt will damage the coating.
Step 11:
Once excess glue is removed, run glue cycle for 30-50 min with glue dryer on.
Step 12:
Wipe off the glue from the Press Roller, with the help of cleaner damp towel.
