Start-up and operation
44
7.2.1 Thread up the labels
Thread up:
Load the labeler with the required paper web (see drawing below):
Unwind the paper web from the paper roll (a short distance).
Remove all labels on this piece.
Lift up the pressure roller from the traction roller by turning the button
Wind the backing paper around the dispensing, traction roller and pressure roller to the
rewinder core (see drawing below).
Secure the paper in its position with the rewinder clamp.
Press down the pressure roller (turning the button on the pressure roller axle).
Adjust the unwinder disc(s) and the paper guide rings (slide to the outer edge of the
paper web.
Labeler Version right (R)
Labeler Version left (L)
C4300/C7300 –
R
C4300/C7300 –
L
1 - paper web:
outside labels
2 -
paper web:
inside labels
7.3 The most important mechanical adjustments
7.3.1 Force of the paper break
Adjustment
The factory has set the paper break to an optimal value. If you have
to change the adjustment – use the M3-screw (2) in the paper
break housing on the outside of the labeler:
Turn out the screw = increase break force
Turn in the screw = reduce break force
2
1
2
1