coldline W10T, Руководство по обслуживанию

Страница: 35 / 96

35
Р
у
сс
к
и
й
It
a
lia
n
o
E
n
g
lis
h
D
e
u
tc
h
F
ra
n
ça
is
Detailed commands sequence:
Detailed commands sequence: Detailed commands sequence:
Detailed commands sequence:
1. Make sure the appliance is in standby standby standby standby mode (6.1 6.1 6.1 6.1).
2. Press button to call up an existing program.
•
DY1
DY1 DY1
DY1 reads “P
PP
P1111”.
3. Use buttons and to select the number of the available program.
4. Press button to start the blast chilling/blast freezing cycle.
10.0 HACCP ELECTRONIC RECORDER (optional)
The electronic recorder is connected directly to the main control panel. It is used to record and produce a
paper printout of temperature and time data relating to the blast chilling and blast freezing cycles.
Maximum roll dimensions
Maximum roll dimensions Maximum roll dimensions
Maximum roll dimensions:::: carta termica 58×Ø30 mm.
Print width
Print width Print width
Print width:::: 48 mm.
Number of dots per line
Number of dots per line Number of dots per line Number of dots per line:::: 384.
Print density
Print density Print density Print density:::: 8 punti per mm.
Serial communication
Serial communication Serial communication Serial communication:::: RS485.
Switching on/off
Switching on/off Switching on/off Switching on/off
1.
To switch the instrument on/off, press the button.
Manual paper feed
Manual paper feed Manual paper feed
Manual paper feed
1.
To feed the paper through manually, press the button.
Replacing paper
Replacing paper Replacing paper
Replacing paper
1.
Switch the instrument off using the button.
•
The led button comes on.
2. Open the front using the button.
3. Insert the roll of paper under the roller.
4. Hold the button down until the roller starts pulling the roll of paper.
5. Position the roll of paper in the relevant slot.
6. Close the front.
Print test
Print test Print test Print test
1.
Switch off the instrument.
2. Press the button....
3. Switch the instrument on.
11.0 OPERATING TIPS AND WARNINGS
Pre Pre Pre Pre----ccccooling ooling ooling ooling
1
Soft blast chilling
2
Start
Before blast chilling/blast freezing, it is best to pre-cool the compartment by running a temperature-based
soft cycle.
Avoid opening the doors while a blast chilling/blast freezing cycle is running.