COFFEtek VITRO X3, Техническое руководство

Страница: 9 / 69

COFFEtek LTD
9 23/02/17 Issue 1 VITRO X3
GENERAL DESCRIPTION
8. The Vitro X3 Beverage Machine is a table top unit which may be mounted on a secured
table, bench, cabinet or food and drink counter.
Cabinet Front
9. The cabinet front door has a large glass panel and located within this panel are 10
capacitive touch switches. On the rear of the door is the display for accessing product
information and machine settings with an internal keypad which provides access to the
Operator’s and Engineer’s Program and a USB port
10. The panel can, when unscrewed, be hinged to give access to the ZMCU control board,
button control board, ZMCU adaptor and capacitive touch PCB’s.
Cabinet Rear
11. The rear lower portion on the cabinet has six screws which if removed allow the espresso
boiler, solid state replay, pump and valves to be accessed by sliding the metalwork which
all of this is mounted onto out.
Cabinet Interior
12. A swivel open door provides access to the three plastic product containers, each fitted with
a gear driven worm screw located in the base of each canister to dispense ingredients in
exact amounts. Accessed through the lid of the machine is the forth bean hopper canister.
The ingredients are mixed with hot water in mixing bowls prior to the beverage being
poured from the dispense head.
A plastic agitator is located inside of the milk topping and chocolate canister to ensure free and
consistent flow of product. Additionally a whipper unit, located beneath the mixing bowls,
ensures that the product and water are correctly mixed.
The ingredient canisters must be removed for filling of the products and when all four canisters
are removed and steam hoods of the mixing bowls are removed the extract chamber can be
removed for cleaning.
13. Located on the rear of the machine on the back left hand panel is the machine on/off
switch, which controls the power to the MPU, power supply. Access to all other components
is either by removal of the lid assembly/boiler cover and motor shelf.
14. Further access to the inner components is achieved by removing the left-hand side panel
by unscrewing the location screw and then the panel will drop down clear of its keyhole
slots. Removing this panel gives access to all internal components.
15. The mains electricity supply cable enters the machine via a cable gland on the base panel
of the machine, where it terminates in a terminal block. The supply is then connected via
the terminal block, line filter to the on/off switch on the front of the machine.