Club Car 2009 Precedent, Руководство по техническому обслуживанию и ремонту

Страница: 47 / 312

ACCELERATOR AND BRAKE PEDAL GROUP Pedal Group
5
BRAKE PEDAL REMOVAL
1. Remove pedal group from vehicle. See Pedal Group Removal on page 5-1.
2. Remove debris shields (4 and 5) (Figure 5-3, Page 5-4) .
3. Remove four screws (12) securing brake pedal assembly (10) to pedal group mounting plate and pull brake pedal
assembly through bottom of pedal group mounting plate.
BRAKE PEDAL INSTALLATION
1. Insert brake pedal assembly (10) through bottom of pedal group mounting plate and secure with four screws (12)
(Figure 5-3, Page 5-4) .
2. Tighten screws (12) to 100 in-lb (11.3 N·m)
3. Install debris shields (4 and 5).
4. Install pedal group in vehicle. See Pedal Group Installation on page 5-5.
PEDAL GROUP INSTALLATION
1. Connect the wire harness (12) to the throttle position sensor (Figure 5-2, Page 5-2) .
2. Position the pedal group in vehicle and secure with two screws (2) on the driver side and two screws (1) on the
passenger side. Tighten driver side screws (2) to 97 in-lb (11 N·m). Tighten passenger side screws (1) to
18 in-lb (2 N·m).
3. Remove the turnbuckle (6) and apply Loctite 242 to the threaded ends of both the rod from the pedal group (8)
and the brake actuator rod (9). Connect the rods using the turnbuckle (6). Ensure the ends of the brake cables do
not slip out of the brake equalizer during this procedure.
4. Adjust the brake cable equalizer tension. See Brake Cable Equalizer Adjustment on page 6-10.
5. Place floor cover plate (7) over the floor opening and secure with fastener (10) (Figure 5-2, Page 5-2) .
6. Install the floor mat (2) over the pedal group. Make sure tabs on floor mat sides are beneath the sill (3). Tighten
screws (1) to 53 in-lb (6 N·m)
(Figure 5-1, Page 5-1) .
2009 Electric Precedent Maintenance and Service Manual Page 5-5