Club Car 2009 Precedent, Руководство по техническому обслуживанию и ремонту

Страница: 219 / 312

SECTION 15 — ELECTRICAL COMPONENTS
15
DANGER
• See General Warnings on page 1-1.
WARNING
• See General Warnings on page 1-1.
KEY SWITCH
See General Warnings on page 1-1.
TESTING THE KEY SWITCH
See Test Procedure 8 – Key Switch and Throttle Position Sensor Limit Switch Circuit on page 11-20 or 12-20.
KEY SWITCH REMOVAL
1. Disconnect the battery cables and discharge the controller as instructed. See WARNINGS “To avoid
unintentionally starting...” and “After disconnecting the batteries, wait 90 seconds...” in General
Warnings on page 1-1.
2. Remove the instrument panel (Figure 15-1, Page 15-2) .
2.1. Remove three screws (1) from the instrument panel (2).
2.2. Rotate the instrument panel up and away from the dash to disengage the tabs at the top of the panel.
2.3. Disconnect the electrical connector (3) to the instrument panel.
3. Disconnect the wires from the key switch.
4. From the back of the instrument panel, push down on the retaining tabs surrounding the key switch (4) and
remove the key switch cap (8). Hold the key switch and remove the switch retaining nut (6) from the outside
of the instrument panel
(Figure 15-2, Page 15-2) .
KEY SWITCH INSTALLATION
1. Position the key switch and flat washer (9) in the instrument panel, then install and tighten the switch retaining nut
(6) to 40 in-lb (4.5 N·m). Install key switch cap (8) in center dash
(Figure 15-2, Page 15-2) .
2. Connect the blue and green wires to the key switch terminals. Either orientation is correct. See Wiring Diagrams
on page 11-2 or 12-2.
3. Install the instrument panel.
3.1. Connect the electrical connector (3) (Figure 15-1, Page 15-2) .
3.2. Position the instrument panel (2) on the dash assembly. Make sure tabs on upper edge properly engage
with the corresponding slots on the dash assembly. Ensure that there are no wires exposed or pinched
during positioning.
2009 Electric Precedent Maintenance and Service Manual Page 15-1