Club Car 2009 Precedent, Руководство по техническому обслуживанию и ремонту

Страница: 289 / 312

TRANSAXLE (TYPE G) Transaxle Disassembly, Inspection, and Assembly
19
8. Disassemble the differential gear case:
8.1. Remove the hex bolts (33) and the ring gear (32) from the differential case (Figure 19-5, Page 19-3) .
8.2. Remove the ring gear.
8.3. Separate the differential gear case housing. If necessary, install two of the hex bolts (removed previously in
step 8.1.) into the differential gear unit and, while holding the unit slightly above the work area, lightly tap
the bolt heads
(Figure 19-14, Page 19-9) . Remove the two bolts.
772
Figure 19-14 Separate Housing
8.4. Remove the differential pin (31) by pushing pin through differential gear case from one side (Figure 19-5,
Page 19-3) . See also Figure 19-15, Page 19-9.
8.5. Remove the idler gears (1 and 2) and thrust plates (3 and 4) (Figure 19-16, Page 19-9) .
1
5
6
26
2
8
7
3
4
773
Figure 19-15 Differential Pin
774
Figure 19-16 Left Differential
8.6. Remove the differential gears (5 and 6) and thrust plates (7 and 8).
8.7. Inspect the bearings (13) of the differential case (26) and replace them if they are damaged (Figure 19-5,
Page 19-3) . To remove them, press them off. See following CAUTION.
CAUTION
• Do not reuse bearings after removing them. Replace bearings with new ones.
9. Inspect parts for wear or damage. Any worn or damaged parts should be replaced. See following NOTE.
NOTE: Damaged or worn gears should be replaced as sets.
2009 Electric Precedent Maintenance and Service Manual Page 19-9