Club Car 2009 Precedent, Руководство по техническому обслуживанию и ремонту

Страница: 225 / 312

ELECTRICAL COMPONENTS Throttle Position Sensor
15
3. Return electronics module to its original location and secure with bolt (11) (Figure 15-8, Page 15-11) . Tighten
bolt to 40 in-lb (4.5 N·m).
4. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first. Tighten
battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector Spray (CCI P/N
1014305) to minimize corrosion.
CAUTION
WARN
ING
WARNING
RUN
TOW
3
4
1
2
709
Figure 15-6 Tow/Run Switch
THROTTLE POSITION SENSOR
See General Warnings on page 1-1.
TESTING THE THROTTLE POSITION SENSOR
See Test Procedure 4 – Throttle Position Sensor Voltage on page 11-16 and Test Procedure 8 – Key Switch and
Throttle Position Sensor Limit Switch Circuit on page 11-20.
See Test Procedure 4 – Throttle Position Sensor Voltage on page 12-16 and Test Procedure 8 – Key Switch and
Throttle Position Sensor Limit Switch Circuit on page 12-20.
THROTTLE POSITION SENSOR REPLACEMENT
The throttle position sensor itself is not intended to be replaced. If sensor is determined to need replacing through
test procedures listed above, the accelerator pedal assembly must be replaced.
See Accelerator Pedal Removal
on page 5-3.
2009 Electric Precedent Maintenance and Service Manual Page 15-7