Club Car 2005 Precedent, Техническое обслуживание и сервис

Страница: 36 / 212

BODY AND TRIM Canopy – Two-Passenger
Page 4-16 2005 Precedent IQ System Electric Golf Car Maintenance and Service Manual
4
Rear Beauty Panel Installation
1. Install rear beauty panel (12) on vehicle. Make sure body clips on the rear of the beauty panel engage
the mating slot in the rear underbody. Secure beauty panel in place with four screws (13). Tighten screws
to 3.7 ft-lb (5 N·m)
(Figure 4-8, Page 4-11) .
2. Connect the three wires to the Forward/Reverse switch (16) as shown.
3. Position the Forward/Reverse switch housing (15) on the front of beauty panel (12) and secure with two
screws (14). Tighten screws to 20 in-lb (2.3 N·m).
4. Install seat support. See Seat Support Installation on page 4-13.
Access Panel
Access panel (6) is secured to the rear underbody (4) with two expanding screws (7) (Figure 4-8, Page 4-11) .
When replacing the panel, tighten screws (7) enough to hold the panel in place.
Rear Underbody Removal
1. Remove four screws (5) attaching the rear underbody (4) to vehicle (Figure 4-8, Page 4-11) .
2. Lift the rear edge of the rear underbody (4) until the front portion slides out from beneath the front under-
body. Remove the rear underbody from the vehicle.
Rear Underbody Installation
1. Install rear underbody (4) on the vehicle (Figure 4-8, Page 4-11) . Install four screws (5) to secure the
underbody to its vehicle. Tighten screws (5 and 18) to 3.7 ft-lb (5 N·m).
CANOPY – TWO-PASSENGER
See General Warnings, Section 1, Page 1-1.
CAUTION
• To prevent damage to the canopy, do not remove the canopy supports (3, 7, and 10) from the
vehicle without first removing the canopy (1) (Figure 4-12, Page 4-17).
TWO-PASSENGER CANOPY REMOVAL
1. Remove the two nuts (9) and two bolts (8) from the canopy (1) and each front canopy support (7 and 10)
(Figure 4-12, Page 4-17) .
2. Remove the nuts (5) and bolts (4) from the canopy (1) and each rear support (3).
3. Lift canopy (1) away from front canopy supports (7 and 10) and rear supports (3).
4. Remove screws (14) securing front canopy support covers to front body.
5. Slide canopy support covers (12 and 13) up front canopy supports (7 and 10) to gain access to bolts (11).
6. Remove two bolts (11) from each front canopy support (7 and 10) and remove canopy supports from the
vehicle.
7. Remove two bolts (6) from each rear support (3) and pull rear supports from vehicle.