Club Car 2005 Precedent, Техническое обслуживание и сервис

Страница: 141 / 212

ELECTRICAL COMPONENTS Solid State Speed Controller
2005 Precedent IQ System Electric Golf Car Maintenance and Service Manual Page 12-11
12
SOLID STATE SPEED CONTROLLER
See General Warnings, Section 1, Page 1-1.
Testing the Solid State Speed Controller
See Test Procedure 5, Section 11, Page 11-18.
Speed Controller Removal
1. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warnings, Section 1, Page 1-2.
2. Remove electronics module cover. See Electronics Module Cover Removal on page 12-5.
3. Remove electronics module assembly from the vehicle. See Electronics Module Removal on
page 12-10.
4. Remove the three self-tapping screws (1) that hold the controller to the component mounting plate and
remove the controller from the vehicle (Figure 12-10, Page 12-12) .
Speed Controller Installation
1. Install the three self-tapping screws (1) that hold the controller to the component mounting plate and
tighten to 5.5 ft-lb (7.5 N·m) (Figure 12-10, Page 12-12) .
2. Install electronic module assembly in the vehicle. See Electronics Module Installation on page 12-10.
3. Install electronics module assembly cover. See Electronics Module Cover Installation on page 12-5.
4. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector
Spray (CCI P/N 1014305) to minimize corrosion.
5. Place the Tow/Run switch in the RUN position.
6. Inspect the vehicle for proper operation.
ý
WARNING
• Make sure that the vehicle operates in the forward direction when the Forward/Reverse switch
is in the FORWARD position.
• Make sure that the vehicle operates in the reverse direction when the Forward/Reverse switch
is in the REVERSE position. The reverse buzzer will sound as a warning when the Forward/
Reverse switch is in REVERSE.
• Make sure that the vehicle does not operate when the Forward/Reverse switch is in the
NEUTRAL position.