ELECTRICAL SYSTEM AND TESTING
Test Procedures
Page 11-20
2005 Precedent IQ System Electric Golf Car Maintenance and Service Manual
11
TEST PROCEDURE 7 – BATTERY PACK VOLTAGE (UNDER LOAD)
See General Warnings, Section 1, Page 1-1.
1. Be sure the batteries are fully charged and that the electrolyte level is correct in all cells.
2. Connect the tester leads to the positive (+) post of battery no.1 and negative (–) post of battery no. 4
(Figure 11-9, Page 11-20)
3. Turn the discharge machine on and record the voltage reading of battery pack while under load.
4. A fully charged set of batteries in good condition should read between 46-49 volts while under load.
5. A reading of 32-46 volts indicates discharged or failed batteries. Each battery should be checked with a
multimeter while under load.
6. A reading of 32 volts or less will not activate discharge machine. If the voltage of the batteries is below
32 volts, the batteries are deeply discharged or have failed.
7. Recording the battery pack voltage reading while under load provides a more accurate diagnosis of the
condition of the batteries. When the discharge machine is ON, it places the battery pack under load and
many times can help determine if one or more batteries in the set have failed. Testing battery voltage
while the batteries are not under load will not always indicate the true condition of the batteries. For more
information about the batteries, refer to Section 13 – Batteries.
TEST PROCEDURE 8 – KEY SWITCH AND MCOR LIMIT SWITCH CIRCUIT
See General Warnings, Section 1, Page 1-1.
Key Switch and MCOR Limit Switch Circuit Test with the IQDM Handset
1. Place chocks at the front wheels and lift the rear of the vehicle with a chain hoist or floor jack. Position
jack stands under the frame rails just forward of each spring mount.
See WARNING “Lift only one
end...” in General Warnings, Section 1, Page 1-2.
2. Turn the key switch to the OFF position and place the Forward/Reverse switch in the NEUTRAL position.
3. Connect the IQDM to the vehicle as described in the IQDM Owner’s Manual.
4. Test the key switch.
4.1. Access the Test menu and select KEY INPUT by using the SCROLL DISPLAY buttons. The IQDM
should indicate OFF when the key switch is in the OFF position.
Figure 11-9 Battery Discharge Test
2
3
4
FRONT
OF VEHICLE
TESTER
BLACK PROBE
TO BATTERY NO. 4 (–)
RED PROBE
TO BATTERY
NO. 1 (+)
1
Содержание 2005 Precedent
