Club Car 2005 Precedent, Техническое обслуживание и сервис

Страница: 27 / 212

BODY AND TRIM Kick Plate and Charger Receptacle Bezel
2005 Precedent IQ System Electric Golf Car Maintenance and Service Manual Page 4-7
4
FLOOR MAT RETAINER REMOVAL
1. Remove screws (2) from top of retainer (1) (Figure 4-4, Page 4-6) .
2. Remove screw (4) from lower rear corner of retainer. This screw threads into a J-clip (5) that is attached
to the rear underbody.
3. Carefully pull on retainer to separate the trim clips from their respective slots. Trim clips do not normally
need to be removed from the retainer.
FLOOR MAT RETAINER INSTALLATION
1. Position the retainer on the vehicle and press firmly to engage the trim clips to the vehicle (Figure 4-4,
Page 4-6) .
2. Install one screw (4) at the lower rear of the retainer. Tighten screw to 1.8 ft-lb (2.5 N·m).
3. Ensure the floor mat is properly positioned beneath the top flange of the retainer and install two screws
(2). Tighten screws to 4.4 ft-lb (6.0 N·m).
KICK PLATE AND CHARGER RECEPTACLE BEZEL
See General Warnings, Section 1, Page 1-1.
KICK PLATE AND CHARGER RECEPTACLE BEZEL REMOVAL
1. If charger bezel (4) requires removal, use charger bezel tool (CCI P/N 102562401) to remove bezel from
the kick plate (Figure 4-5, Page 4-8) .
2. Remove floor mat. See Floor Mat and Retainers, Section 4, Page 4-6.
3. Remove three screws (1) that hold the kick plate (2) to the vehicle.
4. Remove the two front screws (3) that hold the beauty panel to the vehicle. Raise the forward portion of
the rear beauty panel to disengage it from the tabs on the upper portion of the kick plate.
5. Remove kick plate from vehicle.
KICK PLATE AND CHARGER RECEPTACLE BEZEL INSTALLATION
1. Position the kick plate (2) on the vehicle and secure with three screws (1) (Figure 4-5, Page 4-8) . Ensure
front lower edge of rear beauty panel mates with the kick plate. Tighten screws to 3.3 ft-lb (4.5 N·m).
2. Install two front screws (3) to secure the rear beauty panel. Tighten screws to 3.7 ft-lb (5 N·m).
3. Install floor mat. See Floor Mat and Retainers, Section 4, Page 4-6.
4. Snap charger bezel (4) in place on the kick plate.