Club Car 2005 Precedent, Техническое обслуживание и сервис

Страница: 137 / 212

ELECTRICAL COMPONENTS Electronics Module Cover
2005 Precedent IQ System Electric Golf Car Maintenance and Service Manual Page 12-7
12
MOTOR CONTROLLER OUTPUT REGULATOR (MCOR)
See General Warnings, Section 1, Page 1-1.
Testing the MCOR
See Section 11, Test Procedure 4, Page 11-17 and Test Procedure 8, Page 11-20.
MCOR Removal
1. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warnings, Section 1, Page 1-2.
2. Remove pedal group. See Pedal Group Removal, Section 5, Page 5-1.
3. Disconnect the two-pin and three-pin connectors (1) from the MCOR (2) (Figure 12-7, Page 12-7) .
4. Remove the hex-head screws (3) connecting the MCOR to the pedal group.
MCOR Installation
1. Secure the MCOR (2) to the pedal group with two hex-head screws (3) (Figure 12-7, Page 12-7) .
Tighten screws to 23 in-lb (2.6 N·m).
2. Connect the two-pin and three-pin connectors (1) from the wire harness to the MCOR.
3. Install the pedal group. See Pedal Group Installation, Section 5, Page 5-6.
4. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector
Spray (CCI P/N 1014305) to minimize corrosion.
Figure 12-7 Motor Controller Output Regulator
2
3
1