ELECTRICAL COMPONENTS
Electronics Module Cover
2005 Precedent IQ System Electric Golf Car Maintenance and Service Manual
Page 12-5
12
ELECTRONICS MODULE COVER
See General Warnings, Section 1, Page 1-1.
The electronics module cover needs to be removed to gain access to the electronics module, the Tow/Run
switch, and hour meter.
Electronics Module Cover Removal
1. Disconnect the battery cables as instructed.
See WARNING “To avoid unintentionally starting...” in
General Warnings, Section 1, Page 1-2.
2. Remove the screw (1) that holds the cover (2) over the electronics module
(Figure 12-5, Page 12-5)
.
3. Hold battery wire out of way and lift cover (2) off the vehicle.
Electronics Module Cover Installation
1. Hold battery wire out of way and place cover (2) over the electronics module.
2. Install screw (1) to secure cover in place. Tighten screw to 3.4 ft-lb (4.6 N·m).
CAUT ION
• Exposure to water many damage electronic components.
- Do not operate vehicle without this cover properly installed.
- Do not direct water stream in the area of the cover.
3. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector
Spray (CCI P/N 1014305) to minimize corrosion.
Figure 12-5 Electronics Module Cover
1
2
TOW/RUN
SWITCH BRACKET
ELECTRONICS
MODULE
Содержание 2005 Precedent
