Club Car 2005 Precedent, Техническое обслуживание и сервис

Страница: 119 / 212

ELECTRICAL SYSTEM AND TESTING Test Procedures
2005 Precedent IQ System Electric Golf Car Maintenance and Service Manual Page 11-29
11
• Tow/Run switch for proper operation. See Test Procedure 6 – Tow/Run Switch on page 11-19.
Test Procedure 9F – Pin 9
See General Warnings, Section 1, Page 1-1.
Pin 9 in the 16-pin connector provides a connection point for the Tow/Run switch to the speed controller. The
switch provides a +48 volt signal to the speed controller through pin 9 when the Tow/Run switch is in the RUN
position.
1. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warnings, Section 1, Page 1-1.
2. Place chocks at the front wheels and lift the rear of the vehicle with a chain hoist or floor jack. Position
jack stands under the frame rails just forward of each spring mount. See WARNING “Lift only one
end...” in General Warnings, Section 1, Page 1-2.
3. Disconnect the 16-pin connector at the speed controller.
4. Using a multimeter set for 200 volts DC, insert the red (+) probe of the multimeter into pin 9 (gray wire)
of the 16-pin connector. See following CAUTION. Using an alligator clip, connect the black (–) probe to
the B– terminal of the speed controller (Figure 11-15, Page 11-30) .
CAUTION
• Do not fully insert probes into the 16-pin plug. Doing so can result in a poor connection.
5. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m).
6. With the Tow/Run switch in the TOW position, the multimeter should indicate zero volts.
7. Place the Tow/Run switch in the RUN position.
Figure 11-14 Pins 8 and 16 Test
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
!
!
COM 200nA
MAX
1000 ---
750V
FUSED
SPEED CONTROLLER
200 DCV SETTING
(READING WITH
TOW/RUN SWITCH IN RUN
AND FORWARD/REVERSE SWITCH
IN FORWARD)