Club Car 2005 Precedent, Техническое обслуживание и сервис

Страница: 146 / 212

BATTERIES Battery Care
Page 13-2 2005 Precedent IQ System Electric Golf Car Maintenance and Service Manual
13
Battery Replacement, Continued:
3. If the battery cables are to be reused, inspect them for broken or frayed wires, damaged terminals, or
worn insulation. Remove any corrosion on the connectors. A solution of baking soda and water (1 cup
(237 mL) baking soda per 1 gallon (3.8 L) of water) does an excellent job of neutralizing and removing
the corrosion. Be careful not to allow the baking soda solution to enter the battery.
4. Check and clean the battery rack and hold-downs. The nuts and bolts on the hold-downs may corrode.
It is therefore advised they be cleaned periodically and replaced as necessary.
5. Install batteries in the proper orientation (Figure 13-1, Page 13-2) . Install battery hold-downs. The hold-
downs should be tight enough so batteries do not move while vehicle is in motion, but not so tight as to
crack or buckle battery case. Tighten to 97.4 in-lb (11 N·m), alternating between hold-down bolts.
6. Install wires in proper sequence (Figure 13-1, Page 13-2) . Install black wire to negative post of battery
no. 4 last. Make sure all connections are tight. Tighten to 110 in-lb (12.4 N·m). Coat all terminals with Bat-
tery Terminal Protector Spray (CCI P/N 1014305) to minimize future corrosion.
7. Give the batteries a full charge prior to operation. This ensures all the batteries are fully charged and the
cells are equalized prior to use.
BATTERY CARE
See General Warnings, Section 1, Page 1-1.
PREVENTIVE MAINTENANCE
To keep batteries in sound operating condition, follow these steps on a regular basis.
1. Any corrosion build-up on or around batteries should be removed immediately. Terminal connections should
be clean and tight. Any frayed or worn wires should be replaced. After all cables have been connected, coat
all terminals with Battery Terminal Protector Spray (CCI P/N 1014305) to help prevent future corrosion.
Figure 13-1 IQ System Battery Configuration
1
2
3
4
RED
BLA
CK
BATTERY
BANK