Cloos NexT 452 AC, Руководство по эксплуатации

Страница: 78 / 234

78
MAIN (2) - Config (Configuration)
9.6 Config - Clock
For an exact data recording during weld data monitoring the exact time
and the correct data are important. You can enter this data in the "Config
- Clock" menu. Use the arrow symbols to switch between the individual
menu items. The input is made with rotary knob 3.
The input is finished by pressing rotary knob 3. To exit the menu, press the
"Esc" key.
9.7 Config - Process monitoring
Arc existing process control
If the signal "Arc existing" is not active for more than 1 second during the
welding process (process phase), the error message "Err. 23 Arc failure pro-
cess phase" will appear on the display.
You have the following options:
• Off
• Reset on Start
The error message is reset at the next "Welding start" signal.
• Reset from external
The error message is reset by an external signal (OMI or bus system).
Ignition control
If there is no signal "Arc existing" within 5 seconds after the command
"Start welding", the error message "Err. 24 Arc failure ignition phase" will
appear on the display.
You have the following options:
• Off
When the ignition control is off, wire feed will continue in case of a trouble
signal.
• Reset on Start
The error message is reset at the next "Welding start" signal.
• Reset from external
The error message is reset by an external signal (OMI or bus system).
INFO!
Puls 4 -Takt
V
0
A
1.2 mm Fe
82% Argon 18% Co
2
0.0
Konfig – Prozessüberwachung
LB-Steht Prozesskontrolle
Reset bei Start
Funktion
Zündkontrolle
Reset bei Start
Funktion
Puls 4 -Takt
V
0
A
1.2 mm Fe
82% Argon 18% Co
2
0.0
Puls 4 -Takt
V
0
A
1.2 mm Fe
82% Argon 18% Co
2
0.0
Konfig – Prozessüberwachung
LB-Steht Prozesskontrolle
Reset bei Start
Funktion
Zündkontrolle
Reset bei Start
Funktion
Figure 49. "Config" - "Process monitoring" menu