Cloos NexT 452 AC, Руководство по эксплуатации

Страница: 61 / 234

61
9.1.1 Display brightness
You can change the values by means of rotary knob 3.
Standby
If there is no entry via the operating module for more
than 10 minutes, the brightness of the display will be
reset to the given brightness value (%).
Normal oper-
ation This parameter is used to adjust the brightness of the
display during normal operation (%).
9.1.2 MHW x10 Master
Herewith one of the following parameters is defined for the additional
torch triggers.
Function Description
Setting param-
eters
The setting parameters "Power", "Fine" (arc length),
"Dynamics" and "Job" can be activated and varied by the
torch triggers during the welding process.
Except for the "Job" setting parameter, the interval and
step size can be adjusted on the operating module. If the
"Job" setting parameter has been selected, the step size
is automatically set to 1.
Interval
Using this function, you set the speed of the parameter
change released by the torch trigger. The adjustment is
between 1 … 10. The correction value is 100 ms each.
Step width
Using this function, you set the size of the parameter
change released by the torch trigger. The adjustment
is between 1 … 20. The correction value is 0.1 m/min
each for the "Power" and 1 % each for the "Fine" and
"Dynamic" parameters.
9.1.3 Control coolant pump and fan
If an external cooling is connected, make sure that it is recognised by the
welding power source. The functions described here are then transferred
to the external cooling.
Function Description
Automatic
Depending on the thermal load, the calculator of the
welding power source controls the running time of the
cooling pump and the fan.
On
As soon as the main switch of the welding power source
is switched on, the cooling pump and the fan start their
continuous operation.
The pump and the fan only turn off if the welding power
source is switched off.
Off The pump and the flow monitoring are switched off.
The menu is quit by pressing rotary knob 3!
INFO!